The Pulsed Galvanic Stimulator is a High Voltage Galvanic system. This device is battery powered and generates small pulses of electrical current. The output signal has a "twin-peak monophasic wave form with a fixed duration." Each pulse is much shorter in duration ( 5 µS ) and can thus safely deliver much higher voltage than a conventional stimulator.
Please Note:
•
FDA requires a prescription for the sale of electrotherapy devices to individuals in the U.S.
•
NO PRESCRIPTION is required if you are only purchasing replacement pads for your TENS device
•
You can use our Word file at our PRESCRIPTION LINK, or your Health Care Provider can use his/her own prescription form.
Protective top cover flips off to expose Channel On/Off and amplitude control knobs.
HOW TO USE THE GALVANIC STIMULATOR PGS-123:
The dispersive electrode completes the patient circuit.
The Pulsed-Galvanic Stimulator has fully adjustable amplitude ( voltage) and the rate of the twin pulses is adjustable from 2 pairs ( two pulses ) per second to 100 pairs per second.
The LED indicator shows the battery condition and function mode. When the power switch is turned on, the LED will shine green color; but If the battery power is low, the it will be red. During the alternation mode, the LED will alternate between red and green.
All the selectors, controls and switches are very clear and easy to use. Skin Preparation:
The treatment site should be carefully examined and cleaned. An alcohol wipe is recommended.
Electrode Preparation:
•
Clean the electrode application sites.
•
Apply gel in an even layer (about as thick as a match book cover ) to the bottom of the electrode. Avoid using excessive amounts of gel.
•
Attach the electrode to the skin with adhesive tape. Be sure that all sides are evenly taped and that the electrode is held firmly against the skin.
Note: If using self-adhesive electrodes, you can skip previous 2 steps.
•
Insert the pin connector into the electrode socket. For some electrode locations, it may be preferable to insert the pin connector before attaching the electrode to the skin.
The following procedure will ensure a safe and comfortable treatment.
•
Set all dials and switches to zero.
•
Attach the active electrode directly over the treatment site.
Attached the dispersive pad nearby.
•
Set the pulse rate as directed by your doctor.
•
Select the desired polarity and function mode as directed by your doctor.
•
Turn the power on. (LED will be shine green.)
•
Slowly turn up the amplitude until you reach the amount of stimulation recommended by your doctor.
•
The duration of treatment should be as recommended by your doctor.
•
The amplitude is gradually reduced to zero when the treatment has been completed.
•
Turn the power off.
•
Remove electrodes. Unplug the lead cable from the device. Also disconnect the lead cable from the electrode. Wash the conductive rubber electrode after every several uses. Dry before storing.
12 pcs 1.5 " x1.5" + 2 pcs 3 1/8" x 5 7/8" Gel Pads ONLY USD $34.95
NEW MODEL!
BIOFEEDBACK HIGH VOLTAGE TENS
Avazzia Best Series
1.
FDA, CE & CB Approval
2.
HIGH VOLTAGE (Maximum Output 450V, other tens 350V) , MICRO-CURRENT BIOFEEDBACK TENS
3.
Portable model, NO ELECTRODE PAD NEEDED!
4.
3 Models for Minor Chronic, Sport Injury, and Chronic Conditions
HANDHELD TENS-
The Electro-Acupuncture Device is a home therapy device designed for easy self-application of modern medical treatment methods.
XIAO HUA TUO NO Prescription Required For Canada Only
This new TENS requires no prescription and comes in three models to fulfill all your needs. The Non Prescription TENS models comes with accessories for the ear, the breast, and the foot, all at an affordable price.
View My Cart
