High volt pulsed galvanic stimulation may be used, with a physician's prescription for a variety of reasons.
They include maintaining or increasing range of motion, re-educating muscles, reducing motor spasticity, increasing local blood circulation, preventing or retarding disuse atrophy and managing post-traumatic or post-surgical pain conditions.
Please Note:
•
FDA requires a prescription for the sale of electrotherapy devices to individuals in the U.S.
•
NO PRESCRIPTION is required if you are only purchasing replacement pads for your TENS device
•
You can use our Word file at our PRESCRIPTION LINK, or your Health Care Provider can use his/her own prescription form.
GALVANIC STIMULATOR SD-610D HVG BASIC PACKAGE
1.
2mm Lead Wires x 3
2.
Eelectrode Pads x 4
3.
Adapter x 1
4.
Main Unit x 1
5.
User Manual x 1
6.
Black Plastic Shell x 1
GALVANIC STIMULATOR SD-610D HVG FEATURES:
•
Suitable for everyone, pocket size, belt clip attached
•
Reducing muscle spasticity
•
Protective top cover flips off to expose Channel On/Off and amplitude control knobs.
•
Easy-to-read LCD screen
HOW TO USE GALVANIC STIMULATOR SD-610D HVG:
SET KEYPAD:
Adjustable the PR, Alternating/Synchronous, Positive/Negative of Adj. Mode setting.
Adjustable mode has four types such as A-P, A-N, S-P, and S-N. Time setting is 20 min.
A: Alternative; S: Simultaneous; P: Positive Wave; N: Negative Wave
Amplitude: adjustable, 10-300V, 500ohm load
Frequency: adjustable, 1-150Hz pulses per second
Time setting: from 20-1 minutes.
PRE-PROGRAMMED MODES:
1.
Pre.I
2.
Pre.II
Wave Form: Twin peaked mono-phase spike
Mode Alternating: Rate 60Hz fixed
Polarity: alternating, negative
Time Setting: 20 to 1 minutes.
Wave Form: Twin peaked mono-phase spike
Mode Alternating: Rate 120Hz fixed
Polarity: alternating, negative
Time Setting: 20 to 1 minutes
3.
Pre.III
4.
Pre.IV
Wave Form: Twin peaked mono-phase spike.
Mode Alternating: Rate 1-120Hz(rate modulation)
Total Cycle Time: 40 seconds
Modulation Time: 15 seconds on 1-10Hz, 5 seconds on 10-120Hz, 5 seconds on 120-10Hz, 15 seconds on 1-10Hz, cycle time 40 sec.
Polarity: alternating negative
Time Setting: 20 to 1 mins.
Pulse Rate: Phase I is 120 Hz, Phase II is 20 Hz and 120Hz.
Polarity: Phase I is positive and Phase II is negative.
Treatment Time: 1 to 80 minutes.
1.
Power OFF
Make sure the power switch is in the OFF position
2.
Slider Cover
A slide - on panel covers the buttons controlling modulations and compliance timer. Your medical professional may wish to set these controls for you and request that you leave the cover in place.
3.
Check / Replace the Battery / Use Adaptor
Replace the battery compartment cover and press to close. Insert the battery into the compartment. if a battery is being used, match the battery terminal"+" and "-" to the l able in the battery compartment.
4.
Clean Your Skin
Before attaching electrodes, identify those areas where your physician has recommended electrode placement.
Each location should be clean, rinsed and thoroughly dried.
5.
Electrode Preparation
Prepare the electrode site before applying the electrodes. This simple but often overlooked step is crucial to the proper performance of your unit. Improperly prepared electrode placement sites are the single greatest cause for poor electrode and / or Classic HVE performance. Refer to Skin Care section for specific suggestions.
6.
Connect lead wires and electrodes
7.
Electrode Placement
8.
Connect lead wires and Main Unit
The wires provided with the system insert into the jack sockets located on right side of the device. Holding the insulated portion of the connector, push the red plug end of wire into the red jack, black plug end of the wire into the black jack.
9.
Power ON
Turn the unit on and choose between pre0programmed or adjustable treatment.
10.
Adjustable Mode
Press the "mode" keypad to desired treatment of choice"Adj."mode. Press"set"keypad to choice four types such as S-P, S-N, A-P, and A-N. Press the "Set" keypad once to access the amplitude"A" or "S". Then, using the ▼or▲keypads, adjust the amplitude "N" or "P' to desired level of stimulation.
Turn the PR knob clockwise to adjust the frequency. The LCD display will default to the patient compliance meter when you've finished. Press the "Set" keypad to desired treatment time. After treatment time setting, the unit will stop output.
Adj., Pre.I ~ Pre.III: from 1 -20min.(1min./step)
Pre.IV: 80 min. fixed
Time Memory
Memory of the accumulated time from 1-999 minutes of executed application.
Treatment Memory
Memory of the last treatment setting.
Display
Showing all chosen function and indicating the condition of the battery.
Low Battery Indicator
indicate symbol by weakness of the battery.
Weight
90grams(without battery)
Dimension
9.5 x 6 x 2.5 (cm) / 3.8 x 2.4 x 1 (inch)
Package Info
Width x Length x High: 21 x 22 x 5 (cm) / 8.4 x 8.8 x 2(inch)
Weight: 565 G / 1.24 LB
Main Unit x 1
Electrode Pad x 4
Electrode wire x 2
Adapter x 1
Manual x 1
12 pcs 1.5 " x1.5" + 2 pcs 3 1/8" x 5 7/8" Gel Pads ONLY USD $34.95
NEW MODEL!
BIOFEEDBACK HIGH VOLTAGE TENS
Avazzia Best Series
1.
FDA, CE & CB Approval
2.
HIGH VOLTAGE (Maximum Output 450V, other tens 350V) , MICRO-CURRENT BIOFEEDBACK TENS
3.
Portable model, NO ELECTRODE PAD NEEDED!
4.
3 Models for Minor Chronic, Sport Injury, and Chronic Conditions
HANDHELD TENS-
The Electro-Acupuncture Device is a home therapy device designed for easy self-application of modern medical treatment methods.
XIAO HUA TUO NO Prescription Required For Canada Only
This new TENS requires no prescription and comes in three models to fulfill all your needs. The Non Prescription TENS models comes with accessories for the ear, the breast, and the foot, all at an affordable price.
View My Cart
